Thanks for any help y’all can offer! I gave them different port numbers in the camera Ip config in BI and then went into the google WiFi app and forwarded that port (for example put xxx.xxx.65:82 and then for that forwarded port 82 in the google WiFi app for that camera, I think that’s how you do it but I could be totally messing up). Click the camera on the software and the configuration of CCTV camera is done. (CCTV camera mobile configuration screenshot) 3. Launch the Reolink App or Client and enter the UID to add the security camera. I am able to log in remotely with my phone off network so I don’t think it’s a port issue, especially since it try’s to load? I’m really stumped guys, I’ve literally been working on this for 14 hours straight and I’m pretty sure I have s bald spot from me pulling my hair out. Download the IP camera configuration software Reolink App or Client to your phones or PC. There was at times where BI would load a snapshot of a camera but a few seconds later would go back to No signal. Step 2: Launch the Reolink security camera client on your PC. Is there a way to view all the camera feeds in one location using two different NVR units Thank you. The parsing code is somewhat hairy 4, but other than that, it’s. It speaks the same Baichuan protocol as the camera, and it extracts the video and forwards it to another real NVR client like Blue Iris over RTSP. Neolink is a new client completely from scratch. The only real solution I can think of is to set up two different camera systems.one for the main house and the other for the barn. That’s right: I rewrote Reolink’s software in Rust. I reset all my cameras and have given them static IP in the google app, the reolink client can see all the cameras however when I go into BI it will just say no signal. COBRA 8 Channel 1080p NVR Wireless Security System with Two Weather Resistant Cameras. Hello, I have a farm property where the buildings are too far apart to run cable to connect. My set up Modem into the first google WiFi unit - 24 port network switch- connected to that is another 12 port POE switch that has all my cameras on it. However now I can’t get blue iris to see any of my cameras. Connect your camera to the LAN port of the router with an Ethernet cable. One can hear clearly and the person on the other end does also get a good reception. This has improved to the earlier versions of cameras too. I now have the new Google WiFi mesh system set up. You need to connect the camera to your router using an Ethernet cable first, then configure the camera to connect with WiFi. I am connected to my mesh network, and my camera runs on the 5GHz band. My Netgear router that had all my ip reservations for that camera died on me so I had to get a new router. I had a 8 camera set up with my reolink cameras set up and working perfectly for 2 years now.
0 Comments
Leave a Reply. |